Enerwave ZWN-SC7 Z-Wave Scene Controller 7-Button Switch, 2 Free Wall Plates, NEUTRAL WIRING REQUIRED - White¶

Brief information¶

Ideal retrofit solution, neutral wire is required.

Ease of installation. Requires a Primary Z-Wave Controller for programming (Sold Separately)

Interoperable with other Z-Wave enabled devices

Blue LED indicates the current status of scene

Easily activate up to 7 different scenes for Z-Wave enabled devices when used with a Primary Controller (Sold Separately)

How to add to VENUS app¶

1. Activation

Press “Add button” (button ‘+’) in app

Supply power to device

Blue LED will blink when device has not been added to network

LED will not blink when it is added to network

Wait for VENUS scan & detect this device and inform in app

2. Reset then re-add

Press “Add button” (button ‘+’) in app

Press and hold the BIGGEST(7) button of scene controller for 3 seconds, the TOP 2 LEDs will be turned on.

Press and release the TOP-LEFT(1) button, LED will drop down to the MIDDLE LEFT(3).

Press and release the MIDDLE-LEFT(3) button, LED will drop down to the BOTTOM-LEFT(5).

After you press the BUTTOM-LEFT(5) button, it will run into manual learning for about 5 seconds.

All LEDs will blink slowly

Wait for VENUS scan & detect this device and inform in app

Configuration description¶

There is no configuration in this device.

Factory reset¶

Press and hold the BIGGEST(7) button of scene controller for 3 seconds, the TOP 2 LEDs will be lit up

Press and release the TOP-RIGHT(2) button, LED will drop down to the MIDDLE-RIGHT(4)

Press and release the MIDDLE-RIGHT(4) button, LED will drop down to the BUTTOM-RIGHT(6)

After you press the BUTTOM-RIGHT(6) button, it will run into factory default.

Once the controller is reset successfully, all LEDs will flash 3 times and stay on